Druckansicht der Internetadresse:

Fakultät für Biologie, Chemie und Geowissenschaften

Makromolekulare Chemie I: Prof. Hans-Werner Schmidt

Seite drucken
Muth, M.A.; Mitchel, W.; Tierney, S.; Lada, T.A.; Xue, X.; Richter, H.; Carrasco-Orozco, M.; Thelakkat, M.: Influence of charge carrier mobility and morphology on solar cell parameters in devices of mono- and bis-fullerene adducts, Nanotechnology, 24(48), 484001 (1-6) (2013) -- DOI: 10.1088/0957-4484/24/48/484001
Herein, we analyze charge carrier mobility and morphology of the active blend layer in thin film organic solar cells and correlate them with device parameters. A low band gap donor–acceptor copolymer in combination with phenyl-C61-butyric acid methyl ester (PCBM) or two bis-adduct fullerenes, bis-PCBM and bis-o-quino-dimethane C60 (bis-oQDMC), is investigated. We study the charge transport of polymer:fullerene blends in hole- and electron-only devices using the space-charge limited current method. Lower electron mobilities are observed in both bis-adduct fullerene blends. Hole mobility, however, is decreased only in the blend containing bis-oQDMC. Both bis-adduct fullerene blends show very high open circuit voltage in solar cell devices, but poor photocurrent compared to the standard PCBM blend for an active layer thickness of 200 nm. Therefore, a higher short circuit current is feasible for the polymer:bis-PCBM blend by reducing the active layer thickness in order to compensate for the low electron mobility, which results in a PCE of 4.3%. For the polymer:bis-oQDMC blend, no such improvement is achieved due to an unfavorable morphology in this particular blend system. The results are supported by external quantum efficiency measurements, atomic force microscopy, transmission electron microscopy and UV/vis spectroscopy. Based on these results, the investigations presented herein give a more scientific basis for the optimization of solar cells.
Youtube-KanalKontakt aufnehmen
Diese Webseite verwendet Cookies. weitere Informationen