Druckansicht der Internetadresse:

Fakultät für Biologie, Chemie und Geowissenschaften

Makromolekulare Chemie I: Prof. Hans-Werner Schmidt

Seite drucken
Herrmann, F.; Muhsin, B.; Singh, C.R.; Shokhovets, S.; Gobsch, G.; Hoppe, H.; Presselt, M.: Influence of Interface Doping on Charge-Carrier Mobilities and Sub-Bandgap Absorption in Organic Solar Cells, Journal of Physical Chemistry C, 119(7), 9036–9040 (2015) -- DOI: 10.1021/acs.jpcc.5b00124
Abstract:
P3HT:PCBM (poly(3-hexylthiophene-2,5-diyl):([6,6]-phenyl-C61-butyric acid methyl ester)-based bulk heterojunctions (BHJs) were doped by using 4-toluenesulfonic acid (TSA) as dopant. This approach was inspired by the well-known interfacial doping of the active layer via the electron-blocking layer PEDOT:PSS (poly(3,4-ethylenedioxy-thiophene):poly(styrenesulfonate)) at its interface. TSA is amphiphilic, acidic, and structurally very similar to the monomeric building block of PSS. Upon TSA doping, a notable increase in the light absorption in the sub-bandgap region of pristine P3HT was observed. These features are assigned to polaron transitions within P3HT; however, the TSA impact on polaron absorption features in the BHJ is rather small. Although, for small TSA concentrations and thick active layers (∼220 nm) the fill factor of the solar cells improved dramatically with increasing TSA content in the active layer, which is discussed in terms of contact resistances at interfaces in the present paper. For 0.5% TSA concentration in the active layer solution the maximum of the power conversion efficiency was obtained. At the same time, the reproducibility of solar cell performance parameters was considerably improved.
Youtube-KanalKontakt aufnehmen
Diese Webseite verwendet Cookies. weitere Informationen